Start page Basic filtering materials Filtering polymeric materials FPM

Filtering polymeric materials FPM

FPM are intended for thin clearing of air and gases from the suspended fragments (aerosols, dust, fogs) and fabrication of filtering half masks "Lepestok".

FPM can be used to equip filtering half masks of other types, for aerosol filters, for fabrication of complex clearing filters.

For specialists

Filtering polymeric materials FPM

The filtering fibrous layer of materials is hydrophobic, stable in relation to the diluted acids and alkalis, alcohols, saturated hydrocarbons, glycerine, oils and petroleum, salt and sweet water, is diluted in aromatic and chlorinated hydrocarbons and esters, and ketones.

The fibres are placed on a substrate of gauze or non woven material. The material also can be made without a substrate.

FPM is produced as flat sheets or rolls.

FPM has a high and stable electrostatic charge, supplying high filtering properties in the event that the consumer observes the conditions for storage and exploitation.

The FPM material is manufactured in two types: FPM-70 and FPM-15, which differ in the average diameter of the fibres.

In turn, each type of a material is subdivided on some marks distinguished by the thickness of the filter layer and, accordingly, filtering efficiency.

The characteristics of the basic marks of FPM are given in the table.

The material can be used at temperatures up to 85°С and relative humidity up to 98 %. The recommended temperature range of exploitation is from -30°С up to +70°С and relative humidity up to 80 %. With an increase of these limits a decrease in filtering properties is possible; the mechanical properties are stable up to 75°С, irrespective of humidity.

The conformity of FPM to the technical requirements within 5 years as of the moment of fabrication is guaranteed if the consumer satisfies the external environment, transportation and storage conditions indicated in the technical requirements.

strong>TECHNICAL CHARACTERISTICS

N Parameter the norm for the marks
FPM 7003 FPM 7006 FPM 1506 FPM 1508 FPM 1515 FPM 1530 FPM 1545
1 Surface density of fibrous layer, g/м2 20-30 30-40 12-18 15-25 30-40 40-60 60-80
2 Resistance to an air stream at the filtration rate of 1 cm/s, Pa, at most 3.0 6.0 6.0 8.0 15.0 30.0 45.0
3 Penetration rate of an oily fog with average particle diameters of 0.28-0.34 mm, at a velocity of 1 cm/sec, %, at most:
-at acceptance test
-within warranty period
4
10
0,5
1,0
0,5
3,0
0,3
3,0
0,01
0,1
0,005
0,01
0,0001
0,005
4 Mechanical properties:
-breaking load, N, at minimum
-relative elongation at break, at minimum
3.0
0.5
5.0
0.5
0.5
0.5
0.6
0.5
2,0
0.5
2.0
0.5
3.0
0.5
Dimensions of sheet, mm
-length, m
-width, mm
1480 – 1530
850 - 900 or 670 – 690
Dimensions of the roll:
- width, mm
- length, m
680 – 720
3 - 100 (customer requirement)

Note:

1. One sheet 1500 х 670 mm has been calculated as 1 m2. One sheet 1500 х 880 has been calculated as 1.32 м2.

2. The dimensions of the sheet shown in the table can be varied if agreed with customer.